Building Department

Building Permit Requirements

PERMITS

bullet

A building permit shall be obtained before construction begins.

bullet

Constructing, altering, or adding to a structure or moving a structure from one location to another requires a building permit.

bullet

Manufactured (modular, mobile) structures require a permit for the tie-downs.

bullet

Plans for the construction of foundations and/or basements on which the manufactured structure sets are required.

bullet

Structures shall be located within setback requirements and shall not be located on utility, road, or irrigation easements or rights-of-way.

bullet

Fences six feet (6') and under are not required to have a building permit, however, the owner is advised that, if it becomes necessary to remove the fence, it will be done at the owner's expense.

bullet

Fences shall not interfere with visibility at intersections.

 

INFORMATION ON PLANS AND SPECIFICATIONS
 

bullet

Plans and specifications are required PRIOR to issuance of a building permit.

bullet

Plans (drawings) shall be drawn to a professional standard, to scale, upon substantial paper, and be of sufficient clarity to indicate the nature and extent of the work proposed.

bullet

Plans shall include a plot plan showing the location of all existing and proposed structures on the parcel and their distance from the property lines and road rights-of-way.

bullet

Plans shall contain floor plans that include foundations and/or basements, all floor levels, lofts, patios, porches, balconies, carports, garages, and outbuildings.

bullet

Plans shall include exterior structure dimensions and square footage with separate figures for living space, basement, carport/deck, garage, etc. (UBC 106).

 

Cross-section drawings of building(s) shall include:

bullet

Footings and foundations;

bullet

Spans for floor joists and materials (clearance between bottom of floor joist, or bottom floors without joists, and the ground shall be no less than 18 inches; minimum under girders shall be 12 inches);

bullet

Spans for roof trusses or stacked roof--include type of materials to be used;
Spacing of wall studs and materials used;
Type of finishing materials (interior/exterior).

bullet

Computation, stress diagrams, and other data sufficient to show the correctness of the plan shall be submitted when required by the building official.

 

          NOTE:

bullet

Footings - 24 inches deep (below frost line or back filled)

bullet

Snow load in recreation area -- 120 lbs. p/s/f/ live load.

bullet

Snow load for remaining area -- 30 lbs. p/s/f/ live load.
 

Building Inspector:      Myron Adamson

                                 Assistant:                Kacey Hultenius     Ext. 254        

                                   

                 Phone:                       208.587.2130 Extension 510
              Address:                     Growth and Development
                                    520 East 2nd South
                                                 Mountain Home Idaho 83647

                          Hours:                       8:00am 5:00pm Monday thru Friday